Tripp Lite SMART1500LCDXL SmartPro 1500VA Line Interactive UPS 900W 120V 15A

Balance Tech
In stock


Tripp Lite SMART1500LCDXL SmartPro 1500VA Line Interactive UPS 900W 120V 15A
Tripp Lite's SMART1500LCDXL Line-Interactive UPS System offers network-grade voltage regulation, surge suppression and long-lasting battery support, ideal for network equipment, phone systems, desktop PCs and home entertainment systems. Uninterruptible Power Supply / UPS system provides battery derived AC output to maintain continuous operation of connected equipment without data-loss during power failures and severe voltage fluctuations. Runtime is expandable with one additional BP24V15RT2U external battery pack. Interactive LCD display offers detailed site voltage and UPS status information, plus a variety of UPS control options. High 97% efficient line power mode operation offers reduced UPS energy consumption and BTU heat output. Automatic Voltage Regulation / AVR circuits boost brownouts and reduce overvoltages from 75V to 147V to safe 120V nominal levels without using battery power. Included mounting accessories enable 2U horizontal rackmount installation in 2 and 4 post racks or upright tower installation. Built-in USB and DB9 serial port enables optional unattended system shutdown in case of extended power failure using PowerAlert UPS management software. HID-compliant USB interface enables integration with built-in power management and auto shutdown features of Windows and Mac OS X. Built-in data line surge suppression jacks offer protection for equipment with single-line dialup, DSL or network Ethernet connection.

Output Volt Amp Capacity (VA):1500
Output kVA capacity (kVA):1.5
Output Watt Capacity (watts):900
Nominal Output Voltage(s) Supported:115V 120V
Frequency compatibility:60 Hz
Output voltage regulation (line mode):-18%, +8%
Output voltage regulation (Battery mode):115V (+/- 5%)
Built-in UPS output receptacles:8 5-15R outlet(s)
Output AC waveform (AC mode):Sine wave
Output AC waveform (battery mode):PWM sine wave
Rated input current (at maximum load):8.5A
Nominal Input Voltage(s) Supported:120V AC
UPS input connection type:5-15P
UPS input connection description:Space-saving right angle input plug
Input circuit breaker:10A
UPS Input cord length (ft.):6
UPS Input cord length (m):1.8
Recommended Electrical Service:15A 120V
Full load runtime (minutes):4 min. (900w)
Half load runtime (minutes):12 min. (450w)
External battery pack compatibility:BP24V15RT2U (limit 1)
DC system voltage (VDC):24
Battery recharge rate (included batteries):Less than 4.5 hours from 10% to 90%
Voltage regulation description:Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 75 to 147
Overvoltage correction:Input voltages between 128 and 147 are reduced by 12%
Undervoltage correction:Input voltages between 93 and 107 are boosted by 14%
Severe undervoltage correction:Input voltages between 75 and 92 are boosted by 30%
LED Indicators:Front panel LCD display
Front panel LCD display:Numeric LCD interface reports Input Voltage, Output Voltage, Battery Charge Percentage, Estimated Runtime in Minutes, Load Percentage, Load Watts Additional LCD icons report battery charge level (5 "bars"), Line Power Mode, Battery Mode, Replace Battery and Auto-Voltage Regulation / AVR status LCD interface control options include Alarm Disable, Display Scrolling, Initiate Self-test, LCD brightness, External Battery setting and line sensitivity
Alarms:Audible alarm indicates power-failure and low-battery conditions Alarm can be permanently silenced via LCD interface
Alarm cancel operation:Power-fail alarm can be silenced using alarm-cancel switch once silenced, alarm will re-sound to indicate low-battery status
Switches:2 Switches control off/on power status and alarm-cancel/self-test operation dimmer switch controls LCD brightness
UPS AC suppression joule rating:1038
UPS AC suppression response time:Instantaneous
UPS Dataline suppression:1 line TEL/DSL (1 in / 1 out) 10/100Base T Ethernet
EMI / RFI AC noise suppression:Yes
Communications interface:USB (HID enabled) DB9 Serial Contact closure
Network monitoring port description:Supports detailed monitoring of UPS and site power conditions
PowerAlert software:Free download from
Communications cable:USB and DB9 Serial cabling included
WatchDog compatibility:Supports Watchdog application, OS and hard-reboot restart options for remote applications
Transfer time:4 milliseconds AC to battery mode / 3 milliseconds battery to AC mode
Low voltage transfer to battery power (setpoint):75
High voltage transfer to battery power (setpoint):147
Cold Start (startup in battery mode during a power failure):Cold-start operation supported
Green and high efficiency features:Greater than 95% efficiency - GREEN UPS

UPS Certifications:Tested to UL1778 (USA) Tested to CSA (Canada) Tested to NOM (Mexico) Meets FCC Part 15 Category B (EMI)
Item Dimension (L"xW"xH"):
7.5 x 21.5 x 15

40 lb

Warranty Information:
3-year limited warranty

Mfg Part #:
Part #:

Good to know